What hot water flow rate will I get, and is my mains supply good enough?

  • Thermal Stores
  • 3 min read
  • Updated 7th October, 2026
answer

With good incoming mains pressure, an Advance thermal store gives 20 to 30 litres of hot water a minute, enough for a shower at about 9 litres a minute and another tap at the same time. A gas combi typically manages 9 to 12. To check your supply, time a cold mains tap filling a marked bucket: 10 litres in 30 seconds means 20 litres a minute.

Expect 20 to 30 litres a minute

With the right incoming pressure, an Advance Appliances thermal store gives 20 to 30 litres of hot water a minute. A shower typically uses about 9 litres a minute, so you can run a shower and another tap at the same time, and a bath fills in a few minutes. By Advance's figures, a gas combi typically gives 9 to 12 litres a minute.

The hot water leaves the store through a blending valve set at 50°C, which can be adjusted. Advance advises against setting it at maximum, as that uses up the store's energy too quickly.

Your mains supply needs at least 2 bar

Because the hot water comes straight from the mains through the store's coil, the flow you get depends on the supply coming into the property. The Advance standard thermal store installation guide recommends:

  • A minimum of 2 bar pressure through a 22mm pipe. Below this, performance may suffer.
  • A flow rate above 18 litres a minute.
  • A 3 bar control valve if the pressure is likely to go above 3 bar.

Mains pressure usually rises from late evening to early morning, so test at the times you use the most water. Checking the supply before installation is the responsibility of the installer and the householder.

How to check your supply

  1. Turn on a cold tap that is fed from the mains, usually the kitchen cold tap.
  2. With it still running, turn on a second mains tap, such as an outside tap. This shows you what you would get with two outlets open at once.
  3. To measure the flow, time how long one tap takes to fill a bucket marked in litres. If 10 litres takes 30 seconds, your flow is 20 litres a minute.

Keeping the flow rate up

In hard water areas, scale can build up quickly and reduce both flow and efficiency. Advance recommends a water softening treatment where hardness is above 200ppm. If the flow drops, check the incoming supply first and make sure all valves are fully open. An annual service, including rinsing the blending valve filters, keeps the store working as it should.

Not sure which size of store suits your home? Use the sizing guide.

key takeaways
  • With good mains pressure, an Advance thermal store gives 20 to 30 litres of hot water a minute.
  • That is enough for a shower and another tap at the same time.
  • Advance recommends at least 2 bar through a 22mm pipe and a flow above 18 litres a minute.
  • Test your supply with a marked bucket: 10 litres in 30 seconds is 20 litres a minute.
  • In hard water areas above 200ppm, use a softening treatment to stop scale cutting the flow.

Reviewed by Geoff Egginton

Managing Director, Advance Appliances. 20+ Years experience