Replacing an indirect copper cylinder
An indirect copper cylinder is heated by boiler water running through a coil inside it, usually as part of a Y plan or S plan system with a cold water tank in the loft feeding the hot taps.
An indirect, twin coil thermal store connects to the boiler in the same way. The Advance TSi and TSiC work with Y plan, S plan and W plan systems, so the boiler and controls can usually stay, and only one pump is needed. The difference you notice is at the taps: hot water now comes from the mains, at mains pressure.
Which store to choose
- TSiC (cylinder only) if you want to keep your existing feed and expansion tank.
- TSi if you want the feed and expansion tank built in. It can be sited anywhere in the property.
- TSD or TSDC (direct) if the store is to be heated straight from the boiler water. These need two pumps, and the TSD's feed and expansion section must sit above the radiator circuit.
Replacing a Boilermate, Flomax or Albion Mainsflow
Advance Appliances standard thermal stores are like for like replacements for these older stores. The TSD replaces the Boilermate, Flomax and Albion Mainsflow Direct, and the TSi and TSiC replace Boilermate and Flomax products and the Albion Mainsflow Indirect.
Replacing a Gledhill Pulsacoil
The Advance ECO ETS electric thermal store is designed as a replacement for the Gledhill Pulsacoil, without the complicated printed circuit boards. It is open vented, so it needs no relief valves, tundish or metal discharge pipe. With the optional isolation kit, which must be bought with the store, it can be fitted without an overflow. The ETS 160 suits one bath plus one shower from an overnight charge, and the ETS 210 suits homes with two bathrooms.
Graeme Stansfield of Shower Services in Bury, an installer since 2002, used one to replace a failed unit and said the ETS160 "was easy to install, performed well and was competitively priced."
Before you swap
- Check the mains: the installation guide recommends at least 2 bar through a 22mm pipe and a flow above 18 litres a minute.
- The boiler, or any other heat source, must be able to reach 75°C.
- Make sure the floor will take the weight of the full store, that it is frost free, and that the immersion heaters can be reached for maintenance.
If you are not sure which model replaces your old unit, call Advance on 01543 377723.
- Most old indirect copper cylinders can be replaced by an indirect twin coil thermal store on the existing Y plan or S plan system.
- The TSiC keeps your existing feed and expansion tank; the TSi has one built in.
- Advance stores replace the Boilermate, Flomax and Albion Mainsflow like for like.
- The ECO ETS replaces the Gledhill Pulsacoil, with no relief valves or discharge pipe.
- Check the mains supply and that the boiler reaches 75°C before you swap.
Managing Director, Advance Appliances. 20+ Years experience