Use these Advance Thermal Store Cylinders for the provision of fast, safe hot water provision throughout the house. Site the indirect pattern anywhere in the property, and eliminate all feed tanks as they are designed for use with sealed Y or W plan heating systems.
The direct pattern has to be above the radiator circuit as the water is drawn from the tank for fast heat-up.
These low maintenance pre plumbed units provide flow rates up to 30 litres per minute and if linked to the appropriate gas or oil boiler are suitable for average to larger properties, see the sizing guide below.
The units look smart too, no candle wax foam finish here, just a smart wipe-clean white appliance finish, and the insulation is foam injected for maximum efficiencies.
Stainless steel construction offers a lightweight long life product.
What size do I need ?
Code
Application
Size
Boiler Sizing
(x1000btu) (kW)
Weight
(empty)
Weight
(full)
TSD140
TS1140
Single bath / 1 shower
2/3 bed
1190 x 600*
40
12kW
40kg
190kg
TSD170
TS1170
2 bath
2/3 bed
1380 x 600*
60
18kW
45kg
225kg
TSD210
TS1210
3 bath 4 bed
1630 x 600*
80
24kW
50kg
260kg
TSD250
TS1250
Three bath / 2 shower
5 bed
1880 x 600*
100
30kW
55kg
315kg
Boiler Sizing: Minimum boiler sizes are given. Smaller boilers will increase recovery times and performance may be affected. Modulating boilers may increase recovery times.
*Allow extra 100mm for front fitted components.
How does it work ?
Indirect (TSI)
Direct (TSD)
Thermal Store warranties
Both electric and gas thermal store units are guaranteed for five years. This guarantee is on the tank, we will swap if it leaks. The components are guaranteed for one year. This includes immersion heaters where fitted.
The units need a service every 18 months to two years to check pressures in expansion vessel and reducing valves if fitted. it isn’t a costly or time consuming exercise, but it should be done to maintain warranties.
